lemon-mirror:
Home >> Chrysler >> 2008 >> Crossfire 2D Convertible, Automatic >> Repair and Diagnosis (Single Page) >> Electrical >> Body Electrical >> Power Distribution >> Power Distribution >> Relay Control Module >> Removal >> Removal - Relay Control Module

Removal - Relay Control Module

Fig 1: Locating Clip
GC0035892Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the negative battery cable.
  2. Open the lid to the control module box.
  3. Move the wires away to the side of the box to access the clip (1) that holds the relay control module in the control module box.
  4. Push the clip (1) back away from the relay control module and lift the relay control module out of the control module box.
  5. Remove all of the relay harness connectors from the relay control module.
· About lemon-mirror