Sensor, Knock: Removal: 2.4L

Fig 1: Knock Sensor Components Location (2.4L)

Courtesy of CHRYSLER GROUP, LLC

The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold.

1. Disconnect and isolate the negative battery cable.
   Fig 2: Knock Sensor Components Location & Bolt

   Courtesy of CHRYSLER GROUP, LLC
2. Remove the bolt holding the knock sensor.
3. Remove the sensor with the electrical connector attached.
4. Disconnect the electrical connector from the knock sensor.
   Fig 3: Knock Sensor

   Courtesy of CHRYSLER GROUP, LLC
5. Remove the knock sensor.