lemon-mirror:
Home >> Chrysler >> 2014 >> 300 SRT-8 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine Cooling System >> Engine >> Radiator, Engine Cooling >> Installation >> 3.0L Diesel

3.0L Diesel

Fig 1: Upper Radiator Mounting Brackets Bolts
GC0144643Courtesy of CHRYSLER GROUP, LLC
  1. Position the radiator into engine compartment. Seat the radiator assembly lower rubber isolators into the mounting holes in radiator lower support.
  2. Install the radiator mounting bracket (1) and bolts (2). Tighten to 12 N.m (106 in. lbs.).
    Fig 2: Support Bolt
    GC0144644Courtesy of CHRYSLER GROUP, LLC
  3. Position the condenser on radiator and loosely install the support bolt.
  4. Install upper and lower mounting bolt. Tighten bolts to 10 N.m (88 in. lbs.).
  5. Tighten the support bolt to 10 N.m (88 in. lbs.).
    Fig 3: Air Deflectors
    GC0144642Courtesy of CHRYSLER GROUP, LLC
  6. Install the air deflectors (1).
  7. Position the hood latch release cable (2) through the notch in deflector.
  8. Install the front bumper fascia. Refer to FASCIA, FRONT, INSTALLATION .
  9. Raise the vehicle.
    Fig 4: Lower Radiator Hose
    GC0095212Courtesy of CHRYSLER GROUP, LLC
  10. Install the lower radiator hose (1) and clamp.
  11. Install the belly pan. Refer to BELLY PAN, INSTALLATION .
  12. Lower the vehicle.
  13. Install the radiator fan. Refer to FAN, COOLING, INSTALLATION .
  14. Install the upper radiator upper hose (2). Align hose so it does not interfere with the accessory drive belt or engine. Position hose clamp so it will not interfere with the hood.
  15. Connect the negative battery cable.
  16. Fill the cooling system with coolant. Refer to STANDARD PROCEDURE .
  17. Operate the engine until it reaches normal operating temperature. Check the cooling system and automatic transmission for the correct fluid levels.
· About lemon-mirror