Power Distribution Center: Installation

The Power Distribution Center (PDC) is serviced as a unit with the headlamp and dash wire harness. If any internal circuit of the PDC or the PDC housing is faulty or damaged, the entire PDC and headlamp and dash wire harness unit must be replaced.

1. Install the grommet at the dash panel.
2. Position the PDC in the engine compartment.
3. Align the PDC mounting pin with the inner fender well hole.
4. Place PDC down in engine compartment and install the two retaining screws.
5. Route the headlamp and dash wire harness from the PDC through the engine and passenger compartment, engaging each of the harness retainers to the mounting provisions in the vehicle body and chassis components.
6. Install and tighten the fasteners that secure each of the headlamp and dash wire harness ground eyelets to the vehicle body and chassis components.
7. Reconnect each of the headlamp and dash wire harness connectors.
8. Tighten nut retaining positive battery cable at PDC to 14 N.m (123 in. lbs.).
9. Connect the battery negative cable.