Installation - 2.0L

The camshaft position sensor is mounted to the rear of the cylinder head (Figure ).

The target magnet has two locating dowels that fit into machined locating holes in end of the camshaft.

1. Install target magnet in end of camshaft. Tighten mounting screw to 3.4 N.m (30 in. lbs.) torque. Over torquing could cause cracks in magnet. If magnet cracks replace it.
2. Install camshaft position sensor. Tighten sensor mounting screws to 9 N.m (80 in. lbs.) torque.
3. Place brake booster hose and electrical harness in holders on end of valve cover.
4. Attach electrical connectors to camshaft position sensor.