lemon-mirror:
Home >> Dodge and Ram >> 2004 >> SRT-4 >> Repair and Diagnosis >> Engine Performance >> System >> Fuel Delivery >> Fuel Tank >> Installation

Fuel Tank: Installation

  1. Position fuel tank on transmission jack.
  2. Raise tank into position.
  3. Tighten fuel tank strap nuts to 22.5 N.m (200 in. lbs.) torque. Remove transmission jack. Ensure straps are not twisted or bent.
  4. Connect fuel filler tube tank inlet nipple. Tighten clamp.
  5. Connect EVAP vent hose.
  6. Attach fuel tubes to pump module and chassis fuel tube. Refer to QUICK-CONNECT FITTINGS  in the Fuel Delivery section of this Group.
  7. Attach electrical connector and ground wire to fuel pump module.
  8. Install vapor lines to EVAP canister.
  9. Install EVAP canister.
  10. Lower vehicle.
  11. Fill fuel tank, install filler cap, and connect battery cable.
  12. Use the DRB scan tool ASD Fuel System Test to pressurize the fuel system. Check for leaks.
· About lemon-mirror