Gas Engine
| 1 - WATER PUMP |
| 2 - MOUNTING BOLT |
| 3 - WATER INLET TUBE NUTS |
| 4 - INLET WATER TUBE |
- Position the water pump assembly (1) and gasket onto the cylinder block.
- Position the water inlet tube (4) and gasket onto the water pump (1).
- Install the mounting bolts (2). Tighten the bolts to 24 N.m (18 ft. lbs.).
- Install the drive belt splash shield.
- Lower the vehicle.
- Install the accessory drive belt. Refer to BELT, Serpentine, Installation .
- Evacuate air and refill cooling system. Refer to Standard Procedure .
- Check cooling system for leaks. Refer to Diagnosis and Testing .