Wireless Charging Pad Module

REMOVAL 

1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
2. Remove the Instrument panel cupholder. Refer to CUPHOLDER, INSTRUMENT PANEL, REMOVAL AND INSTALLATION .
3. Remove the fasteners that secure the wireless charging pad module to the instrument panel cupholder.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Instrument Panel Cupholder

   2 - Fasteners

   3 - Wireless Charging Pad Module

4. Remove the wireless charging pad module.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

• Install the fasteners and tighten securely.