Fuel Injector

On sequential PFI engines, disconnect injector harness connectors. Using digital ohmmeter, check connector terminal resistance of each injector. If resistance is not 11-18 ohms, replace injector. On non-sequential PFI engines, disconnect injector bank harness connector. Check resistance of injector bank. See INJECTOR BANK RESISTANCE table. Repair wiring or any injector not within specification.

INJECTOR BANK RESISTANCE ⁽¹⁾

Engine

Ohms

2.3L

6.0-8.5

⁽¹⁾	Resistance values are for non-sequential PFI engines only.

NOTE: For additional testing and information, see FUEL SYSTEM in appropriate SYSTEM/COMPONENT TESTS article in the ENGINE PERFORMANCE Section.