Single Switch
Remove appropriate single switch from vehicle. Using an ohmmeter, check resistance between specified terminals while operating switch. See appropriate SINGLE SWITCH TESTING table. See Fig 1 or Fig 2 . Replace switch if resistance between specified terminals is 5 ohms or more. DO NOT check resistance between terminals not specified.
SINGLE SWITCH TESTING (RIGHT FRONT DOOR)
| Switch Position | Between Terminals No. |
|---|---|
| Neutral | 6 & 9; 7 & 10 |
| Up | 8 & 10; 6 & 9 |
| Down | 6 & 8; 7 & 10 |
SINGLE SWITCH TESTING (REAR DOORS)
| Switch Position | Between Terminals No. |
|---|---|
| Neutral | 1 & 4; 2 & 5 |
| Up | 3 & 5; 1 & 4 |
| Down | 1 & 3; 2 & 5 |