Mirror Control Switch
Remove mirror control switch. See MIRROR CONTROL SWITCH under REMOVAL & INSTALLATION. Measure resistance between specified mirror control switch terminals (component side) while operating switch as specified. See MIRROR CONTROL SWITCH TEST table. See Fig 1. Resistance in all tests should be less than 5 ohms. If resistances are not as specified, replace switch. Retest system operation.
MIRROR CONTROL SWITCH TEST
| Switch Position | Measure Between Terminals No. | |
|---|---|---|
| Left Mirror | ||
| Up | 1 & 6; 5 & 7 | |
| Down | 1 & 7; 5 & 6 | |
| Left | 1 & 7; 4 & 5 | |
| Right | 1 & 4; 5 & 7 | |
| Right Mirror | ||
| Up | 1 & 6; 5 & 8 | |
| Down | 1 & 8; 5 & 6 | |
| Left | 1 & 8; 4 & 5 | |
| Right | 1 & 3; 5 & 8 | |