Compressor Driver Module

1.

Remove the rear floor console refrigerator. Refer to Refrigerator .

2.

NOTE: Do not bend the condenser tubes. The screwdriver must fit between the condenser tubes or damage may occur to the refrigerator.

Using a long thin screwdriver, remove the Phillips screw from the compressor driver module mounting bracket.

GFD59813

Courtesy of FORD MOTOR COMPANY

3.

Disconnect the upper electrical connector from the compressor driver module.

GFD59814

Courtesy of FORD MOTOR COMPANY

4.

Rotate the compressor driver module to the right and remove from the mounting bracket.

GFD59815

Courtesy of FORD MOTOR COMPANY

5.

Disconnect the lower electrical connector from the compressor driver module.

GFD59816

Courtesy of FORD MOTOR COMPANY

6.

Disconnect the compressor driver module-to-refrigerator electrical connector.

GFD59817

Courtesy of FORD MOTOR COMPANY

7.

To install, reverse the removal procedure.