Engine Controls - Tests W/O Codes - 6.5L Diesel: Introduction
NOTE:
These models may use Electronic Control Modules (ECM), Powertrain Control Module (PCM) or Vehicle Control Module (VCM). PCM will be used in this article to describe all control modules.
Before diagnosing symptoms or intermittent faults, perform steps in BASIC TESTING - 6.5L DIESEL article and appropriate TESTS W/CODES article below. Use this article to diagnose driveability problems if a hard fault code is not present or if vehicle is not equipped with a self-diagnostic system.
- TESTS W/CODES - 6.5L DIESEL (for C/K Pickup, Sierra Pickup, Suburban, Tahoe & Yukon)
- TESTS W/CODES - 6.5L DIESEL (for "P" & "G" Series Van)
Symptom checks are intended to direct the technician to malfunctioning component(s) for further diagnosis. A symptom should lead to either specific component or system testing or an adjustment specification. Use intermittent test procedures to locate driveability problems which DO NOT occur when the vehicle is being tested.
NOTE:
For specific testing procedures, proceed to the SYSTEM/COMPONENT TESTS - 6.5L DIESEL
article. For specifications, see ADJUSTMENTS - 6.5L DIESEL
or SPECIFICATIONS - 6.5L DIESEL
article in the ENGINE PERFORMANCE section.
NOTE:
SERVICE ENGINE SOON light, located on instrument cluster, is also referred to as the Malfunction Indicator Light (MIL).