Programming Theft Deterrent System Components
NOTE:
This procedure has to be performed only for vehicles equipped with a Passlock System.
Perform the Programming Theft Deterrent System Components , in Theft Deterrent after successfully finishing the BCM programming and setup procedure. If the Programming Theft Deterrent System Components procedure is not performed after a BCM replacement, one of the following conditions will occur:
- The vehicle will not be protected against theft by the PASSLOCK system.
- The engine will not crank or start.
NOTE:
After programming, perform the following to avoid future misdiagnosis:
- Turn the ignition OFF for 10 seconds.
- Connect the scan tool to the data link connector.
- Turn the ignition ON with the engine OFF.
- Use the scan tool in order to retrieve history DTCs from all modules.
- Clear all history DTCs.