lemon-mirror:
Home >> GMC >> 2003 >> Envoy 4WD >> Repair and Diagnosis >> Body & Frame >> Windows >> Stationary Window System >> Repair Instructions >> Windshield Replacement >> Installation Procedure

Installation Procedure

  1. Install a stationary window into the opening. Refer to URETHANE ADHESIVE INSTALLATION OF STATIONARY WINDOWS   . 
  2. Install the windshield side reveal moldings.
    Fig 1: Installing Windshield Side Reveal Moldings
    G01641233Courtesy of GENERAL MOTORS CORP.
  3. Install the windshield side reveal moldings screws.
    NOTE: Refer to Fastener Notice   in Cautions and Notices.

    Tighten 

    Tighten the windshield side reveal moldings screws to 2 N.m (18 lb in).

    Fig 2: Installing Windshield Side Reveal Moldings Screws
    G01641234Courtesy of GENERAL MOTORS CORP.
  4. Install the front door sealing weatherstrips (1) to the retainer (2).
    Fig 3: Installing Front Door Sealing Weatherstrips To Retainer
    G01641235Courtesy of GENERAL MOTORS CORP.
  5. Install the push pin retainers (2) to the front door sealing weatherstrips located at the base of the pillar.
  6. Install the cowl air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT  in Body Front End.
  7. Install the windshield wiper arms. Refer to WIPER ARM REPLACEMENT  in Wipers/Washer Systems.
  8. Install the antenna mast if equipped. Refer to FIXED ANTENNA MAST REPLACEMENT  in Entertainment.
  9. Install the rear view mirror. Refer to REARVIEW MIRROR REPLACEMENT   . 
  10. Install the rain sensor. Refer to WINDSHIELD OUTSIDE MOISTURE SENSOR REPLACEMENT  in Wipers/Washer Systems.
  11. Close the hood.
  12. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
    Fig 4: Installing Push Pin Retainers To Front Door Sealing Weatherstrips
    G01641236Courtesy of GENERAL MOTORS CORP.
· About lemon-mirror