lemon-mirror:
Home >> GMC >> 2016 >> Terrain SL, Gas >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Removal Procedure

Removal Procedure

WARNING:

Refer to Brake Fluid Irritant Warning .

CAUTION:

Refer to Brake Fluid Effects on Paint and Electrical Components Caution .

CAUTION:

Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

  1. Place the ignition switch in the OFF position.
  2. Remove the accessory wiring junction block. Refer to Accessory Wiring Junction Block Replacement .
  3. Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any dirt or debris.
  4. Disconnect the EBCM electrical connector by lifting the locking lever upward.
    5. Fig 1: EBCM Bolts
    GM1873922Courtesy of GENERAL MOTORS COMPANY
  5. Remove the 4 EBCM bolts (1).
    6. Fig 2: EBCM
    GM1873923Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do not pry the components apart.

  6. Carefully pull the EBCM (1) from the BPMV.
  7. Remove the 12 EBCM seals, if necessary.
· About lemon-mirror