lemon-mirror:
Home >> GMC >> 2019 >> Sierra 2500 HD Base, 2D Pickup, Gas >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> K69 Transfer Case Control Module: Programming and Setup >> Programming an Existing or New Control Module

Programming an Existing or New Control Module

To program an existing or new control module, perform the following procedure:

  1. Ignition - On / Vehicle - In Service Mode
  2. Access SPS and follow the on-screen instructions for the control module:K69 Transfer Case Control Module
  3. Perform the SPS function:K69 Transfer Case Control Module - Programming
  4. Perform the SPS function:K69 Transfer Case Control Module - Setup
  5. Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to No.
· About lemon-mirror