Removal Procedure
Rear Suspension Cradle (1) - Remove - Rear Suspension Cradle Removal and Installation
Drive Motor Power Inverter Module Bolt (1) - Remove
- Drive Motor Power Inverter Module Nut (2) - Remove
- Drive Motor Power Distribution Control Module Hose (3) - Disconnect
- Rear Electric Drive Transmission Module Coolant Hose (4) - Disconnect
- Remove the drive motor power distribution control module hose retainers (5).
- Drive Motor Power Distribution Control Module Hose (6) - Remove
Drive Motor Power Distribution Control Module Bolt (1) - Remove [3x]
- Drive Motor Power Distribution Control Module Protector (2) - Remove
Remove the high voltage battery positive cable retainer (1).
- NOTE:
Some components not shown for graphic clarity.
Disconnect the electrical connectors. (1)
- Battery Positive Cable Shield Bolt (2) - Remove [2x]
- High Voltage Battery Positive Cable (3) - Reposition
Disconnect the electrical connector. (1)
- Remove the battery positive and negative cable extension cable retainers (2).
- Battery Positive Cable Shield Bolt (3) - Remove [2x]
- Reposition the battery positive and negative cable extension cable (4).
- NOTE:
Some components not shown for graphic clarity.
Battery Negative Cable Nut (1) - Remove [2x]
- Starter Generator Negative Ground Cable (2) - Reposition [2x]
- NOTE:
Some components not shown for graphic clarity.
Drive Motor Power Distribution Control Module Bolt (1) - Remove [4x]
- Battery Charger (2) - Remove
Auxiliary Battery Positive Cable Nut (1) - Remove
- Remove the battery positive and negative cable retainers (2).
- Battery Positive and Negative Cable (3) - Remove
Drive Motor Power Inverter Module Cooling Inlet Hose Bracket Bolt (1) - Remove [2x]
- Drive Motor Power Inverter Module Bracket (2) - Remove
- High Voltage Connector (3) - Remove [2x]