lemon-mirror:
Home >> GMC >> 2024 >> Hummer EV 2 >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup - All Systems >> Repair Instructions >> K107C Drive Motor 3 Control Module: Programming and Setup >> Reprogram Control Module

Reprogram Control Module

To reprogram an existing K107C Drive Motor Control Module 3, perform the following procedure:

  1. Access the Service Programming System (SPS) and follow the on-screen instructions.
    2. NOTE:

    The K107 Drive Motor Control Module, K107B Drive Motor Control Module 2 and K107C Drive Motor Control Module 3 will be programmed together.

  2. On the SPS Supported Controllers screen, select K107 - Drive Motor Control Module - Programming and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select K107 - Drive Motor Control Module - Setup and follow the on-screen instructions.
  4. Clear DTCs.
· About lemon-mirror