Inverter System Protection Function
| Item | Condition | LED Status |
|---|---|---|
| Undervoltage protection | Shuts down for safety at voltages lower than 11.3 V ± 0.3 V. | LED flickering |
| Resumes operation at 12.2 V ± 0.3 V. | LED lighting | |
| Overvoltage protection | Shuts down for safety at voltages higher than 15.5 V ± 0.3 V. | LED flickering |
| Resumes operation at 15.5 V ± 0.3 V. | LED lighting | |
| Overheat protection | Shuts down for safety if temperatures exceed 105°C ± 10°C. | LED flickering |
| Resumes operation at 95°C ± 10°C. | LED lighting | |
| Overcurrent protection | Turns OFF when overcurrent above a set point is detected. | LED lighting |
| The inverter stops for 20 seconds before its restarts. | LED flickering (20 seconds) |
|
| Turns OFF when overcurrent is detected 3 times (turn the AC inverter switch ON again to turn on the inverter). | ||
| short circuit protection | The inverter shuts down for safety if there is a short circuit between the AC1 and AC 2 outputs during operation. | LED OFF |
| undervoltage/overvoltage shutdown protection | Shuts down at voltages lower than 10.7 V ± 0.3 V. | LED OFF |
| Shuts down at voltages lower than 16.5 V ± 0.3 V. | LED OFF |
WARNING:
- DO NOT touch or insert any foreign substance into the AC inverter. Be aware of the potential risk of electric shock or fire.
CAUTION:
- Only use the AC inverter when the engine is running. Always disconnect the inverter when not in use.
- Using the AC inverter when the engine is off or leaving an electric device plugged in for a long time may drain the battery of the vehicle.
- DO NOT use any electric devices that consume more than 220V (200W) of power.
- Connecting an electrical device that generates excessive levels of electromagnetic noise to the AC inverter may cause abnormal sounds in the audio equipment or a malfunction in the vehicle's electronic devices.
- Connecting a faulty electronic device to the AC inverter may damage the inverter or the electric system of the vehicle.
NOTE:
Inspect the battery and recharging system.
- The LED indicator blinks if the AC inverter input voltage falls below 11.3V. The inverter shuts off if the voltage falls below 10.7V.
Inspect the battery and recharging system.