Ignition Switch Replacement

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

1. Do the battery terminal disconnection procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
2. Remove the left front door sill trim and left kick panel (see TRIM REMOVAL/INSTALLATION - DOOR AREAS ).
3. Disconnect the 6P connector (A) from the under-dash fuse/relay box.
   Fig 1: Identifying 6P Connector And Ignition Switch With Screws

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Remove the two screws and the ignition switch (B).
5. Install the switch in the reverse order of removal.
6. Do the battery terminal reconnection procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).