Specifications Index

COMMON SPECS & PROCEDURES INDEX

System		Specification/Procedure
Air Conditioning
Service		HVAC SERVICE SPECIFICATIONS (PLUG-IN)
Torque		TORQUE SPECIFICATIONS (PLUG-IN)
Axle Nut/Hub Nut
328 N.m (242 lbf.ft)
Battery		12 VOLT BATTERY
Brakes
Bleeding Sequence		ELECTRIC SERVO BRAKE SYSTEM BLEEDING
Disc Brakes		BRAKE SYSTEM SERVICE SPECIFICATIONS (PLUG-IN)
Torque		TORQUE SPECIFICATIONS (PLUG-IN)
Charging
Service Specifications		ENGINE ELECTRICAL SERVICE SPECIFICATIONS (PLUG-IN)
Torque		TORQUE SPECIFICATIONS (PLUG-IN)
Drive Belts
Belt Routing & Adjustment		NA
Engine Cooling
General Service Specifications		ENGINE COOLING SERVICE SPECIFICATIONS (PLUG-IN)
Radiator Cap Pressure		93-123 kPa (0.95-1.25 kgf/cm2, 13.5-17.8 psi)
Thermostat R & I		THERMOSTAT
Water Pump R & I		ELECTRIC ENGINE COOLANT PUMP
Engine Mechanical
Compression		930 kPa (9.48 kgf/cm² , 134.9 psi) Minimum 200 kPa (2.04 kgf/cm² , 29.0 psi) Maximum variation
Oil Pressure (176°F (80°C)		80 kPa (0.82 kgf/cm² , 11.6 psi) min. @ idle 330 kPa (3.37 kgf/cm² , 47.9 psi) min. @ 3000 RPM
Overhaul		See applicable specifications tables in ENGINE MECHANICAL SERVICE SPECIFICATIONS (PLUG-IN)
Torque		TORQUE SPECIFICATIONS (PLUG-IN)
Fluid Specifications		See FLUIDS under MAINTENANCE tab.
Flywheel/Flex Plate Torque		74 N.m (55 ft. lbs.)
Fuel System
Pressure Specification		320 - 370 kPa (3.26 - 3.77 kgf/cm2, 46.4 - 53.7 psi)
Fuel Pressure Test Procedure		FUEL PRESSURE
Ignition
Firing Order & Cylinder Identification		FIRING ORDER & CYLINDER IDENTIFICATION
Spark Plug NGK: 7751
Gap		1.0-1.1 mm (0.039-0.043 in)
Torque		22 N.m (16 ft. lbs.)
Starting
Starter		ENGINE ELECTRICAL SERVICE SPECIFICATIONS (PLUG-IN)
Torque		TORQUE SPECIFICATIONS (PLUG-IN)
Wheel Alignment
Adjustment Specifications		SUSPENSION SERVICE SPECIFICATIONS (PLUG-IN)
	Torque	TORQUE SPECIFICATIONS (PLUG-IN)
Wheel & Tire
Wheel Lug Nut Torque		108 N.m (80 ft. lbs.)