lemon-mirror:
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 566 (Door System) >> Repair Instructions >> Module Replacement - Front Power Window >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Power Window Module
    GM838386Courtesy of GENERAL MOTORS CORP.
  1. Place the window module in position in the door.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 5 fasteners (1) to the window regulator.

    Tighten:  Tighten the fasteners to 9 N.m (7 lb ft).

  3. Connect the window motor electrical connector.
  4. Place the window in the window clamps, and tighten the clamps.

    Tighten:  Tighten the clamps to 9 N.m (7 lb ft).

  5. Operate the window module to inspect for proper operation.
  6. Install the water deflector. Refer to Water Deflector Replacement - Front Door .
  7. Install the trim panel. Refer to Trim Panel Replacement - Side Front Door .
· About lemon-mirror