lemon-mirror:
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 775 (Sunroof System) >> Repair Instructions >> Sunroof Module Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sunroof Module Assembly
    GM977375Courtesy of GENERAL MOTORS CORP.
  1. With an assistant, position the new sunroof module assembly into the roof opening.
  2. Install the bolts which secure the sunroof module assembly to the roof and tighten the bolts by hand.
  3. Place a 12 mm (0.47 in) pin into the sunroof module alignment holes.
    4. NOTE: Refer to Fastener Notice .
  4. Remove the alignment pins.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  5. Install the front and rear sunroof drain hoses. Refer to Sunroof Housing Front Drain Hose Replacement  and Sunroof Housing Rear Drain Hose Replacement .
  6. Connect the electrical connectors to the sunroof module.
  7. Secure the harness to the sunroof module.
  8. Adjust the sunroof window. Refer to Sunroof Window Height and Opening Fit Adjustment .
  9. Verify the proper operation of the sunroof before securing the headliner.
  10. With an assistant, install the headliner. Refer to Headlining Trim Panel Replacement .
· About lemon-mirror