lemon-mirror:
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Bracket Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Generator Bracket & Bolts (4.8L, 5.3L & 6.0L)
    GM847280Courtesy of GENERAL MOTORS CORP.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  1. Install the generator bracket.
  2. Install the generator bracket bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  3. Install the power steering pump. Refer to Power Steering Pump Replacement .
  4. Install the generator. Refer to Generator Replacement .
    5. Fig 2: View Of Battery Cable Junction Block Bracket & Bolts
    GM759636Courtesy of GENERAL MOTORS CORP.
  5. Install the battery cable junction block bracket bolts.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

· About lemon-mirror