lemon-mirror:
Home >> Hummer >> 2009 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Cable Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Cables At Junction Block
    GM662521Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the generator cable (2) to the junction block.
  2. Install the generator cable nut and tighten to 9 N.m (80 lb in).
  3. Close the positive cable junction block.
    4. Fig 2: View Of Generator Cable & Nut
    GM395686Courtesy of GENERAL MOTORS CORP.
  4. Install the generator cable to the generator, perform the following:
    1. Install the generator cable to the stud.
    2. Install the generator cable nut and tighten to 9 N.m (80 lb in).
    3. Position the boot to cover the stud.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
· About lemon-mirror