lemon-mirror:
Home >> Hummer >> 2009 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Generator & Bolts
    GM385810Courtesy of GENERAL MOTORS CORP.
  1. Install the generator.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the generator bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    3. Fig 2: View Of Generator Cable & Nut
    GM395686Courtesy of GENERAL MOTORS CORP.
  3. Install the generator cable to the generator, perform the following:
    1. Install the generator cable.
    2. Install the generator cable nut to the terminal stud.

      Tighten:  Tighten the nut to 9 N.m (80 lb in).

    3. Slide the boot over the terminal stud.
    4. Fig 3: Identifying Purge Solenoid Electrical Connector, Wiring Harness Nut & Generator Electrical Connector
    GM663672Courtesy of GENERAL MOTORS CORP.
  4. Connect the generator electrical connector (3).
  5. Install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  6. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
    7. Fig 4: View Of Negative Battery Cable At Battery
    GM832902Courtesy of GENERAL MOTORS CORP.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
· About lemon-mirror