lemon-mirror:
Home >> Hyundai >> 2011 >> Accent GL >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Ignition Switch Assembly >> Ignition Switch >> Repair procedures >> Replacement

Repair procedures: Replacement

  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad lower panel (A).

    (Refer to "CRASH PAD ")

    Fig 1: Identifying Crash Pad Lower Panel
    G06882718Courtesy of HYUNDAI MOTOR CO.
  3. Remove the ignition switch (A) after loosening the screw with IG ON and disconnecting the 6P connector.
    Fig 2: Identifying Ignition Switch
    G06882719Courtesy of HYUNDAI MOTOR CO.
  4. Remove the steering column shaft.

    (Refer to STEERING COLUMN & SHAFT )

  5. Remove the door warning switch after loosening the screws and disconnecting the 6P connector.
    Fig 3: Identifying Door Warning Switch Connector
    G06882720Courtesy of HYUNDAI MOTOR CO.
  6. If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder (A) after pushing lock pin with key ACC.
    Fig 4: Identifying Key Lock Cylinder
    G06882721Courtesy of HYUNDAI MOTOR CO.
  7. Installation is the reverse of removal procedure.
· About lemon-mirror