lemon-mirror:
Home >> Hyundai >> 2011 >> Azera GLS >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Ignition Switch Assembly >> Ignition >> Repair Procedures >> Replacement

Repair Procedures: Replacement

  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad lower panel (Refer to the CRASH PAD ).
    Fig 1: Identifying Ignition Switch
    G07250478Courtesy of HYUNDAI MOTOR CO.
  3. Remove the ignition switch (A) after loosening the screw with IG ON and disconnecting the 6P connector.
    Fig 2: Identifying Key Illumination Lamp And Screws
    G07250479Courtesy of HYUNDAI MOTOR CO.
  4. Remove the steering column shaft (Refer to REMOVAL the ).
  5. Remove the door warning switch and key illumination lamp (A) after loosening the screws (B) and disconnecting the 6P connector.
    Fig 3: Identifying Key Lock Cylinder And Lock Pin
    G07250480Courtesy of HYUNDAI MOTOR CO.
  6. If it is necessary to remove the key lock cylinder (A), Remove the key lock cylinder (A) after pushing lock pin (B) with key ACC.
    Fig 4: Identifying Key Lock Cylinder And Lock Pin
    G07250481Courtesy of HYUNDAI MOTOR CO.
  7. Installation is the reverse of removal procedure.
· About lemon-mirror