Repair Procedures: Installation

Tightening torque 

20.6 ~ 22.6Nm (2.1 ~ 2.3kgf.m, 15.2 ~ 16.6lb-ft)

Fig 1: Locating Oil Pump

Courtesy of HYUNDAI MOTOR CO.

Tightening torque 

18.6 ~ 21.6Nm (1.9 ~ 2.2kgf.m, 13.7 ~ 15.9lb-ft)

Fig 2: Locating Pump Sprocket And Oil Pump Chain

Courtesy of HYUNDAI MOTOR CO.

Tightening torque 

9.8 ~ 11.7Nm (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

Fig 3: Locating Oil Pump Chain Cover

Courtesy of HYUNDAI MOTOR CO.

1. Using a gasket scraper, remove all the old packing material from the gasket surfaces.
2. Before assembling the oil pan, the liquid sealant TB1217H should be applied on upper oil pan. The part must be assembled within 5 minutes after the sealant was applied.

   Bead width:  2.5mm (0.1in.)

   But marked area(*) to be 5.0mm (0.2in.)

   Fig 4: Applying Liquid Sealant on sealant

   Courtesy of HYUNDAI MOTOR CO.
   CAUTION:

   • Clean the sealing face before assembling two parts.
   • Remove harmful foreign materials on the sealing face before applying sealant
   • When applying sealant gasket, sealant must not be protrude into the inside of oil pan.
   • To prevent leakage of oil, apply sealant gasket to the inner threads of the bolt holes.
3. Install lower oil pan.

   Uniformly tighten the bolts in several passes.

   Tightening torque 

   9.80 ~ 11.76Nm (1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)

   Fig 5: Identifying Lower Oil Pan

   Courtesy of HYUNDAI MOTOR CO.
4. After assembly, wait at least 30 minutes before filling the engine with oil.