Wheel Balance

Removal 

1. Remove inner and outer balance weights from the wheel.
   CAUTION:

   • Be careful not to scratch the wheel during removal procedures.
2. Using releasing agent, remove double-faced adhesive tape from the wheel.
   CAUTION:

   • Be careful not to scratch the wheel during removal.
   • After removing double-faced adhesive tape, wipe clean traces of releasing agent from the wheel.

Adjustment 

• If a tire balance machine has adhesion balance weight mode settings and drive-in weight mode setting. select and adjust a drive-in weight mode suitable for wheels.

1. Set wheel on wheel balancer using the center mark as a guide. Start the tire balance machine.
2. Install balance weight.
   CAUTION:

   • Do not install the inner balance weight before installing the outer balance weight.
   • Before installing the balance weight, be sure to clean the mating surface of the wheel.
   Fig 1: Identifying Inner And Outer Balance Weight

   Courtesy of HYUNDAI MOTOR CO.
   1. Install balance weight in the position shown in illustration.
      Fig 2: Balance Weight Installation Position

      Courtesy of HYUNDAI MOTOR CO.
   1. When installing balance weight to wheels, set it into the grooved area on the inner wall of the wheel as shown so that the balance weight center is aligned with the wheel balancer indication position (angle).
      CAUTION:

      • Always use genuine Hyundai adhesion balance weights.
      • Balance weights are not reusable; always replace with new ones.
      • Do not install one balance weight sheet on top of another.
3. Start wheel balancer again.
4. Install drive-in balance weight on inner side of road wheel in the wheel balancer indication position (angle).
   CAUTION: Do not install more than two balance weights.
   Fig 3: Identifying Wheel Balancer Indication Position (Angle)

   Courtesy of HYUNDAI MOTOR CO.

Wheel Nut Tightening 

1. Tightening torque.

   Tightening torque: 

   90 ~ 110N.m (9 ~ 11kgf.m, 65.1 ~ 79.5lb-ft)

   CAUTION: When using an impact gun, final tightening torque should be checked using a torque wrench.
2. Tightening order.

   Check the torque again after tightening the wheel nuts diagonally.

   Fig 4: Wheel Nuts Tightening Order (1 Of 2)

   Courtesy of HYUNDAI MOTOR CO.
   Fig 5: Wheel Nuts Tightening Order (2 Of 2)

   Courtesy of HYUNDAI MOTOR CO.