lemon-mirror:
Home >> Hyundai >> 2011 >> Equus Signature >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Power Trunk Module >> Power Trunk Module Drive Unit >> Repair Procedures >> Installation

Repair Procedures: Installation

  1. Install the power trunk module & drive unit.

    Tightening torque: 

    22~27 Nm (2.2~2.7 kgf.m, 15.9~19.5 lb-ft)

  2. Install the push rod to the ball joint.
  3. Connect the connector (18P).
  4. Install the left trunk trim.
  5. Connect the negative (-) battery terminal and check the power trunk module correctly.
    NOTE:
    • Connect the connectors tightly.
    • Check the power trunk lid for normal operation correctly.
    WARNING:
    • A lost drive unit mounting bolt in the vehicle may make a noise.
    • Don't operate the power trunk lid when a push rod is removed.
    • A learn cycle must be performed whenever the power is removed.
    • Check the normal operating whenever a power tailgate component is removed or replaced. If the chime sound is heard, check the DTC, wiring harness and cable connections.
· About lemon-mirror