Repair procedures: Disassembly

Remove the cover (A) from the front housing.

Fig 1: Identifying Front Housing Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the M-terminal (A) on the starter solenoid assembly (B).

Fig 2: Identifying M-Terminal And Starter Solenoid Assembly
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the 3 screws (A), detach the starter solenoid assembly (B).

Fig 3: Identifying Starter Solenoid Assembly And Screws
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the through bolts (A).

Fig 4: Identifying Through Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the brush holder assembly (A), yoke (B) and armature (C).

Fig 5: Identifying Brush Holder Assembly, Yoke And Armature
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shield (A) and packing (B).

Fig 6: Identifying Shield And Packing
Courtesy of HYUNDAI MOTOR AMERICA
Remove the and lever packing (A).

Fig 7: Identifying Lever Packing
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the planet gear (A).

Fig 8: Identifying Planet Gear
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the planet shaft assembly (A) and lever (B).

Fig 9: Identifying Planet Shaft Assembly And Lever
Courtesy of HYUNDAI MOTOR AMERICA
Press the stopper (A) using a socket (B).

Fig 10: Pressing Stopper Using Socket
Courtesy of HYUNDAI MOTOR AMERICA
After removing the stop ring (A) using stop ring pliers (B).

Fig 11: Removing Stop Ring Using Stop Ring Pliers
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the stopper (A), overrunning clutch (B), internal gear (C) and planet shaft (D).

Fig 12: Identifying Stopper, Overrunning Clutch, Internal Gear And Planet Shaft
Courtesy of HYUNDAI MOTOR AMERICA

NOTE: Using a suitable pulling tool (A), pull the overrunning clutch stopper (C) over the stop ring (B).

Fig 13: Pulling Overrunning Clutch Stopper Using Tool
Courtesy of HYUNDAI MOTOR AMERICA
Reassembly is the reverse of disassembly.