lemon-mirror:
Home >> Hyundai >> 2012 >> Tucson GLS, FWD >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Ignition Switch Assembly >> Ignition Switch Assembly >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the steering column upper and lower shrouds.

    (Refer to the STEERING COLUMN AND SHAFT )

  3. Remove the ignition switch (A) after disconnecting the 6P connector (B).
    Fig 1: Identifying Ignition Switch With Connector
    G06873861Courtesy of HYUNDAI MOTOR CO.
  4. Remove the key warning and immobilizer connector (A).
    Fig 2: Identifying Key Warning And Immobilizer Connector
    G06873862Courtesy of HYUNDAI MOTOR CO.
  5. Remove the key illumination lens (A).
    Fig 3: Identifying Key Illumination Lens
    G06873863Courtesy of HYUNDAI MOTOR CO.
  6. If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder after pushing lock pin (B) with key ACC.
    Fig 4: Removing Key Lock Cylinder After Pushing Lock Pin
    G06873864Courtesy of HYUNDAI MOTOR CO.
· About lemon-mirror