lemon-mirror:
Home >> Hyundai >> 2013 >> Elantra GLS, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle Control System >> Output Speed Sensor >> Repair procedures >> Installation

Repair procedures: Installation

  1. Installation is the reverse of removal.
    NOTE: After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
    • Adding Automatic Transaxle Fluid (ATF).

      (Refer to "FLUID ")

    • Perform Transaxle Control Module (TCM) learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.

      (Refer to "REPAIR PROCEDURE )

    • Use new valve body gasket (A).
      Fig 1: Valve Body Gasket
      G10243338Courtesy of HYUNDAI MOTOR AMERICA
· About lemon-mirror