lemon-mirror:
Home >> Hyundai >> 2016 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Ignition Switch Assembly >> Repair procedures >> Removal >> Notes

Repair procedures: Removal: Notes

  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver crash pad lower panel.

    (Refer to "CRASH PAD ")

  3. Remove the steering column upper and lower shrouds.

    (Refer to "CRASH PAD ")

  4. Remove the wiper switch.

    (Refer to "MULTIFUNCTION SWITCH ")

  5. Remove the ignition switch after disconnecting the ignition switch 6P connector.
  6. Remove the key warning/immobilizer connector (A).
    Fig 1: Identifying Key Warning/Immobilizer Connector
    G10606135Courtesy of HYUNDAI MOTOR AMERICA
  7. After loosening the screw, remove the key warning switch (B).
  8. Pushing lock pin with key ACC.
  9. Remove the key lock cylinder (A).
    Fig 2: Identifying Key Warning Switch And Lock Cylinder
    G10606136Courtesy of HYUNDAI MOTOR AMERICA
· About lemon-mirror