lemon-mirror:
Home >> Infiniti >> 2008 >> M35 Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Control Systems >> Engine Control System (VQ35DE) - Component And System Testing >> ASCD Brake Switch >> Component Inspection >> ASCD Brake Switch

ASCD Brake Switch

  1. Turn ignition switch OFF.
  2. Disconnect ASCD brake switch harness connector.
  3. Check harness continuity between ASCD brake switch terminals 1 and 2 under the following conditions.
    BRAKE PEDAL CONDITION CHART

    Condition Continuity
    Brake pedal: Fully released. Should exist.
    Brake pedal: Slightly depressed. Should not exist.
  4. If NG, adjust ASCD brake switch installation, refer to "BRAKE PEDAL ", and perform step  3 again.
    Fig 1: Checking Harness Continuity Between ASCD Brake Switch Terminals 1 And 2
    G04900677Courtesy of NISSAN MOTOR CO., U.S.A.
· About lemon-mirror