BCM (Body Control Module): Configuration: Description

WARNING: This page is about a different car, the 2010 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

CONFIGURATION has three functions as follows:

READ CONFIGURATION is the function to read (extract) vehicle configuration of current BCM.
WRITE CONFIGURATION-Manual selection is the function to select and write vehicle configuration on BCM manually.
WRITE CONFIGURATION-Config file is the function to write vehicle configuration with the data extracted from current BCM.
For READ CONFIGURATION and WRITE CONFIGURATION-Config file, refer to CONSULT-III Operation Service Information.

For WRITE CONFIGURATION-Manual selection using the following flow chart, identify the correct model and configuration list. Confirm and/or change setting value for each item according to the configuration list. Depending on CONSULT-III software version being used, some or all of the write configuration items shown in the following configuration lists may be displayed. If an item does not appear on the CONSULT-III WRITE CONFIGURATION-Manual selection screen(s), then it is an auto setting item and it cannot be manually set or changed.

NOTE: Confirm vehicle model on IDENTIFICATION PLATE. Refer to "MODEL VARIATION ".

ITEM SPECIFICATIONS

ITEM

SET VAL

KEYLESS ENTRY

WITH ↔ WITHOUT

I-KEY

WITH ↔ WITHOUT

DTRL

WITH ↔ WITHOUT

THEFT ALARM

WITH ↔ WITHOUT

TIRE PRESSURE⁽¹⁾

230kPa or 240kPa

AUTO DOOR UNLOCK TIMING

MODE

⁽¹⁾	Refer to "CONSULT-III FUNCTION (BCM) ".

CAUTION:

When replacing BCM, you must perform WRITE CONFIGURATION with CONSULT-III.
Complete the procedure of WRITE CONFIGURATION in order.
If you set incorrect WRITE CONFIGURATION, incidents will occur.
Configuration is different for each vehicle model. Confirm configuration of each vehicle model.