Work Procedure: Description
Initialize the system if any of the following work has been done.
- When control unit replaced.
- Removal and installation of regulator assembly.
- Disconnection and connection of power window main switch harness connector.
- Removal and installation of motor from regulator assembly.
- Operation of regulator assembly as an independent unit.
- Removal and installation of door glass.
- Removal and installation of door glass run.
CAUTION:
The following specified operations cannot be performed under the non-initialized condition.
- Auto-up operation
- Anti-pinch function
- STEP 1
- Close the door.
- Turn ignition switch ON.
- Operate power window switch to fully open the window. (This operation is unnecessary if the window is already fully open)
GO TO 2.
- STEP 2
Continue pulling the power window switch UP (AUTO-UP operation). Even after glass stops at fully closed position, keep pulling the switch for 2 seconds or more.
GO TO 3.
- STEP 3
Check that auto-up function operates normally.
GO TO 4.
- STEP 4
Check anti-pinch function. Refer to Work Procedure .
END