Work Procedure

Make sure that all of the following conditions are satisfied. Learning will be cancelled if any of the following conditions are missed for even a moment.

• Battery temperature: More than 5°C (41°F)
• Engine coolant temperature: More than 70°C (158°F)
• Shift lever: P or N
• Electric load switch: OFF (Air conditioner, headlamp, rear window defogger)
• Vehicle speed: Stopped
• Transmission: Warmed-up
• Drive vehicle for 10 minutes.

Do you have CONSULT '

>>

GO TO 2.

With CONSULT

1. Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING". Refer to Description .
2. Perform "THROTTLE VALVE CLOSED POSITION LEARNING". Refer to Description .
3. Start engine and warm it up to normal operating temperature.
4. Select "A/F INITIAL LEARNING" in "WORK SUPPORT" mode of "ENGINE" using CONSULT.
5. Touch "START" and wait 20 seconds.

"CMPLT" displayed on CONSULT screen?

>>

INSPECTION END

>>

GO TO 3.

Engine component parts and their installation condition are questionable. Check and eliminate the cause of the incident. It is useful to perform "TROUBLE DIAGNOSIS - SPECIFICATION VALUE". Refer to Description . If any of the following conditions occur after the engine has started, eliminate the cause of the incident and perform "AIR FUEL RATIO INITIAL LEARNING" all over again:

• Engine stalls
• Erroneous idle

>>

INSPECTION END