Work Procedure

Perform the following operations when replacing BCM.

BEFORE REPLACEMENT

When replacing BCM, save or print current vehicle specification with CONSULT configuration before replacement.

NOTE: If "Before Replace ECU" of "Read / Write Configuration" cannot be used, use the "Manual Configuration" after replacing BCM.

AFTER REPLACEMENT

CAUTION:

When replacing BCM, always perform "Read / Write Configuration" or "Manual Configuration" with CONSULT. Or not doing so, BCM control function does not operate normally.

Complete the procedure of "Read / Write Configuration" in order.
Configuration is different for each vehicle MODE l. Confirm configuration of each vehicle MODE l.
If you set incorrect "Read / Write Configuration" or "Manual Configuration", incidents might occur.

NOTE: When replacing BCM, perform the system initialization (NATS) (if equipped).

SAVING VEHICLE SPECIFICATION
CONSULT Configuration: Perform "Before Replace ECU" of "Read/ Write Configuration" to save or print current vehicle specification. Refer to Work Procedure .

NOTE: If "Before Replace ECU" of "Read/Write Configuration" cannot be used, use the "Manual Configuration" after replacing BCM.

>>

GO TO 2.
REPLACE BCM
Replace BCM. Refer to BCM : Removal and Installation .

>>

GO TO 3.
WRITING VEHICLE SPECIFICATION
CONSULT Configuration: Perform "After Replace ECU" of "Read / Write Configuration" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure .

>>

GO TO 4.
INITIALIZE BCM (NATS) (IF EQUIPPED)
Perform BCM initialization. (NATS)

>>

WORK END