lemon-mirror:
Home >> Isuzu >> 1991 >> Impulse XS, 2D Hatchback, Automatic >> Repair and Diagnosis >> Engine Performance >> Sensor Range Charts >> Engine Controls - Sensor Operating Range Charts >> Sensor Range Charts

Sensor Range Charts

COOLANT TEMP SENSOR RESISTANCE

Temperature °F (°C) (1) Ohms
0 (-18) 25,000
20 (-7) 13,500
40 (4) 7500
70 (21) 3400
100 (38) 1800
160 (71) 450
212 (100) 185
(1) Measure resistance across disconnected sensor terminals.
EGR TEMP SENSOR RESISTANCE (CALIF.)

Temperature °F (°C) (1) Ohms
32 (0) 27,000
104 (40) 5800
212 (100) 1000
(1) Measure resistance across disconnected sensor terminals.
MAP SENSOR VOLTAGE

Altitude Feet (1) Volts
Below 1000 3.8-5.5
1000-2000 3.6-5.3
2000-3000 3.5-5.1
3000-4000 3.3-5.0
4000-5000 3.2-4.8
5000-6000 3.0-4.6
6000-7000 2.9-4.5
7000-8000 2.8-4.3
8000-9000 2.6-4.2
(1) Measure voltage at Grey/Red wire terminal.
MAT SENSOR RESISTANCE

Temperature °F (°C) (1) Ohms
0 (-18) 25,000
20 (-7) 13,500
40 (4) 7500
70 (21) 3400
100 (38) 1800
160 (71) 450
212 (100) 185
(1) Measure resistance across disconnected sensor terminals.
OXYGEN SENSOR VOLTAGE TEST (1)

Condition Volts
Lean 0.1
Rich 0.9
(1) Test at normal operating temperature
O2 SENSOR HEATING ELEMENT RESISTANCE TEST(1)

Application (2) Ohms
Impulse & Stylus 3.5-14
(1) Resistance will vary with temperature change.
(2) Measure resistance between Black wire and Light Blue wire terminals.
THROTTLE POSITION SENSOR VOLTAGE(1)

Position (2) Volts
Closed Throttle 0.48
Open Throttle 4.5
(1) For terminal locations, see appropriate WIRING DIAGRAMS article in the ENGINE PERFORMANCE Section.
(2) Voltage should increase smoothly from closed to wide open throttle.
VEHICLE SPEED SENSOR CONTINUITY TEST(1)

Application (2) Continuity
All Models 4 Changes Per Revolution
(1) Measure continuity at back of speedometer. See WIRING DIAGRAMS article in the ENGINE PERFORMANCE Section.
(2) Turn speedometer cable to cycle reed switch on and off.
VEHICLE SPEED SENSOR VOLTAGE TEST(1)

Application (2) Volts
All Models Less than 10
(1) Measure voltage at back of speedometer. See WIRING DIAGRAMS article in the ENGINE PERFORMANCE Section.
(2) With ignition on, turn speedometer cable to cycle reed switch on and off.