Starter Test
NOTE:
Test starter at an ambient temperature of 59-100°F (15-38°C) as readings may vary in different temperature conditions.
- Remove PGM-FI fuse, to disable ignition system. PGM-FI (15-amp or 20-amp) fuse is No. 33 in underhood fuse and relay center. Connect a Voltage/Amperage Tester (VAT), or connect a voltmeter and an ammeter to battery. See Fig 1 .
- Place shift lever in Park or Neutral position (A/T), or depress clutch (M/T). While observing VAT, or meters, crank engine. If cranking voltage does not drop below specification, and current draw does not exceed specification, starter is okay. See CRANKING TEST SPECIFICATIONS
table. If starter does not crank engine, go to next step. If starter cranks erratically or slowly, go to step 6).CRANKING TEST SPECIFICATIONS
Application Cranking Voltage Current Draw (Amps) Odyssey/Oasis 8.5 350 - Load test battery. Check battery cable terminal ends for poor, loose or corroded connections. Check gear position switch (A/T), clutch interlock switch (M/T) or starter relay for poor, loose or corroded electrical connections. Repair or replace as necessary. If all connections are okay, turn ignition switch to START position. If starter cranks engine, system is okay. If starter does not crank engine, go to next step.
- Remove Black/White wire connector from terminal "S" of starter solenoid. See Fig 2 . Connect a remote starter switch between positive battery terminal and terminal "S" of starter solenoid. Depress remote starter switch. If starter does not crank engine, remove starter and diagnose internal problem, or replace starter. See BENCH TESTING . If starter cranks engine, locate and repair open in Black/White wire. If Black/White wire is okay, go to next step.
- Check components of starting circuit. See appropriate tests in ON-VEHICLE TESTING:
- Remove starter. Inspect starter drive gear for damaged teeth. Inspect ring gear of flywheel or flex-plate for damaged teeth. If teeth are not damaged, bench test starter. See BENCH TESTING . If either ring gear or drive gear have damaged teeth, replace as necessary.