Sprag Unit: Reassembly
NOTE:
Flared shoulder of the sprag cage faces the sun gear. This procedure must be followed exactly to be sure that the sprag assembly is installed properly.
- Install rings and sprag assembly onto the third clutch hub and sun gear.
- Install sprag outer race and retaining ring assembly over the sprag cage assembly.
- Place third clutch hub and sun gear assembly on a flat surface, sun gear facing up. Place sprag outer race and sprag assembly over the sun gear assembly, push down and turn the input sun counterclockwise at the same time.
NOTE:
Check correct rotation by holding the sun gear in your left hand and turning the outer race. The outer sprag race should turn freely towards you and should lock turning away from you.