Control Switch Continuity
Control switch continuity test is performed at steering column using an ohmmeter. Refer to following chart to determine switch continuity condition. When using the ohmmeter, the ignition switch must be OFF, otherwise the ohmmeter will be internally damaged.
NOTE:
Pushbutton cannot be depressed with slide switch in "RES" position.
CONTROL SWITCH CONTINUITY CONDITIONS
| Application | Switch Position | Condition | ||
|---|---|---|---|---|
| Red/Brown | "OFF" | Open | ||
| Red/Green | "OFF" | Open | ||
| Red/Yellow | "OFF" | Open | ||
| Red/Brown | "ON" | Closed | ||
| Red/Green | "ON" | Closed | ||
| Red/Yellow | "ON" | Open | ||
| Red/Brown | "RES" | Closed | ||
| Red/Green | "RES" | Closed | ||
| Red/Yellow | "RES" | Closed | ||
| Red/Brown | "ON"(1) | Closed | ||
| Red/Green | "ON"(1) | Open | ||
| Red/Yellow | "ON"(1) | Closed | ||
|
||||