lemon-mirror:
Home >> Jeep >> 1981 >> Pickup J20, AWD >> Repair and Diagnosis >> Engine Performance >> Ignition System >> MOTORCRAFT Solid State Ignition >> Overhaul >> Distributor >> Disassembly

MOTORCRAFT Solid State Ignition: Overhaul: Distributor: Disassembly

  1. Remove distributor cap and rotor. Using suitable gear puller (J-28509), remove trigger wheel (two screwdrivers can be used to pry trigger wheel upward). Remove pin.
  2. On 6 cylinder engines, remove sensor retainer and washers from pivot pin on base plate. On V8 engines, remove sensor snap ring from shaft. Remove retainer from vacuum unit-to-sensor drive pin and move vacuum lever aside.
  3. Remove ground screw from harness tab. Lift sensor assembly from distributor housing. Only remove vacuum unit when it is to be replaced.
· About lemon-mirror