lemon-mirror:
Home >> Jeep >> 1996 >> Cherokee Classic, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 4.0L >> Self-Diagnostic System >> Retrieving DTCS >> Using Scan Tool

Using Scan Tool

  1. Ensure battery is fully charged. Attempt to start engine. Turn ignition off. Connect scan tool to Data Link Connector (DLC). DLC is located below instrument panel near steering column. See Fig 1.
    Fig 1: Locating Data Link Connector (Typical)
    G95B35601Courtesy of CHRYSLER CORP.
  2. Turn ignition on. Using scan tool manufacturer's instructions, record all DTCs displayed on scan tool. Using all DTCs obtained, proceed to SELF-DIAGNOSTIC TESTS . Once all repairs are made, ensure DTCs are cleared from PCM memory. See CLEARING DTCS .
· About lemon-mirror