Service Precautions

Before proceeding with system diagnosis, following precautions must be followed:

• Ensure fuel pressure is released before removing fuel line or fittings, as fuel system is under pressure and may cause personal injury. See FUEL PRESSURE RELEASE  .
• When using self-diagnostic for diagnosis, DO NOT skip any steps, or incorrect diagnosis may result. Always perform indicated Verification (VER) test after repairs are made.
• When using a jumper wire, ensure either jumper wire or circuit is fuse-protected.
• Ensure ignition is off before disconnecting connector from any control module.
• When checking voltage or continuity at any control module, probe connector for control module from pin side. DO NOT probe wire through insulation or backprobe connector (unless instructed to do otherwise in test procedure).
• DO NOT cause short circuits when performing electrical tests. This will set additional Diagnostic Trouble Codes (DTCs), making diagnosis of original problem more difficult.
• Use specified test equipment when performing electrical tests.
• When checking for spark, ensure no fuel leaks exist and spark plug cable or coil wire is NOT more than 1/4" from engine ground. If spark plug or coil wire is more than 1/4" from engine ground, damage to vehicle electronics and/or Powertrain Control Module (PCM) may result.
• DO NOT prolong testing of fuel injectors or engine may hydrostatically lock.
• If replacing PCM, correct vehicle mileage and Vehicle Identification Number (VIN) must be programmed into PCM to prevent DTCs from being set in Anti-lock Brake System (ABS) module and Supplemental Restraint System (SRS) module. See POWERTRAIN CONTROL MODULE PROGRAMMING.
• If replacing PCM on models with a Sentry Key Immobilizer Module (Skim), secret key data must be updated to enable engine starting. To update secret key data, see POWERTRAIN CONTROL MODULE PROGRAMMING.