lemon-mirror:
Home >> Jeep >> 2000 >> Wrangler SE, Automatic >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> On-Vehicle Testing >> Park/Neutral Position Switch

Park/Neutral Position Switch

NOTE: For 4.7L automatic transmission testing, see TRANSMISSION RANGE (TR) SENSOR  .
  1. Place gear selector lever in Park. Disconnect negative battery cable. Raise and support vehicle. Disconnect Park/Neutral switch 3-pin connector. Using an ohmmeter, check for continuity between switch center terminal and good ground. If continuity exists, go to next step. If continuity does not exist, replace faulty switch.
  2. Place gear selector lever in Reverse. Check for continuity between switch center terminal and good ground. If continuity does not exist, switch is okay. If continuity exists, replace faulty switch.
· About lemon-mirror