lemon-mirror:
Home >> Jeep >> 2002 >> Grand Cherokee Overland >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System >> Generator >> Installation

Installation

  1. Position generator to engine and install mounting bolts.
  2. Tighten generator mounting bolts as follows:
    • Vertical mounting bolt 4.7L engine 40 N-m (29 ft. lbs.)
    • Long horizontal mounting bolt 4.7L engine 55 N-m (41 ft. lbs.)
    • Short horizontal mounting bolt 4.7L engine 55 N-m (41 ft. lbs.)
    • Generator mounting bolts 4.0L engine 55 N-m (41 ft. lbs.)
    • B+ terminal nut 11 N-m (95 in. lbs.)
  3. Snap 2-wire field connector into rear of generator.
  4. Snap cable protector cover to B+ mounting stud.
    CAUTION: Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
    CAUTION: When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump will be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or refer to ACCESSORY DRIVE .
  5. Install generator drive belt. Refer to ACCESSORY DRIVE .
  6. Install negative battery cable to battery.
· About lemon-mirror